Filter
Top Products
6-22 Sample Materials
WOOD
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 100 20 500 1 .020”
20 100 27 500 1 .020”
25 100 33 500 1 .020”
30 100 40 500 1 .020”
35 100 47 500 1 .020”
40 100 53 500 1 .020”
45 100 60 500 1 .020”
50 100 67 500 1 .020”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 80 2.5 500 1 .030”
20 80 3.3 500 1 .030”
25 80 4.2 500 1 .030”
30 80 5.0 500 1 .030”
35 80 5.8 500 1 .030”
40 80 6.7 500 1 .030”
45 80 7.5 500 1 .030”
50 80 8.3 500 1 .030”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 50 0.8 250 1 .125”
20 50 1.1 250 1 .125”
25 50 1.3 250 1 .125”
30 50 1.6 250 1 .125”
35 50 1.9 250 1 .125”
40 50 2.1 250 1 .125”
45 50 2.4 250 1 .125”
50 50 2.7 250 1 .125”
COMMENTS
When engraving wood with a laser, a brown, maple syrup like residue will deposit on the surface
of the wood. This is normal and impossible to eliminate by POWER, SPEED, or PPI changes.
More residue will be present when engraving deeper and/or slower. This residue washes off
with water and a sponge. We recommend using a kitchen sponge with a nylon string mesh
wrapped around it. Dampen the sponge and wipe off the residue. A damp chamois cloth works
well also. Do not use paper towels or a regular sponge because these materials will get lodged
in the engraved area when wiping and are extremely difficult to remove. A method to avoid
cleanup is to mask the wood with transfer tape and peel off the tape after engraving. If desired,
after engraving and before peeling off the tape, spray paint can be applied to color fill the
engraved areas. After the paint dries, peel off the tape. If an intricate drawing has been
engraved and there are many small pieces of tape to remove, it may