Filter
Top Products
System Operation 3-15
AIR ASSIST Menu
This class of laser system does have Air Assist as an option, but it is not computer controlled.
Since we use the same menu system on other models, this menu selection for your model does
absolutely nothing. If you did purchase the Air Assist option for this model, please refer to the
instructions that came with that option.
DUAL HEAD Menu
This option is not available for this model of laser system.
CONFIGURATION Menu
Selecting this menu will allow the reconfiguration of certain features of the engraving system and
will lead to other menu items.
SET FOCUS POSITION Menu
This option allows you to set the focus position to anywhere in the field that you desire.
Normally, the factory default setting for the “Z” button is (1,1). If you would like to change the
factory default setting, go to this menu and press the “SELECT” button. If you have the optional
red laser diode pointing device, the light will appear on the engraving table to assist you in
determining the position desired.
Using the motion control arrow buttons to position the focus carriage assembly. While you are
doing this can observe the coordinate display change as you move the focus carriage. These
coordinates are the current position of the focus assembly in the engraving field. Once the
desired position has been located, bring the cursor down to the “YES SAVE POSITION” line and
press the “SELECT” button. Press the “ESCAPE” button twice to exit back to the “MAIN” menu.
Your settings will automatically be retained permanently in memory.