Filter
Top Products
6-16 Sample Materials
MAT BOARD
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 90 80 250 1 .005”
20 68 80 250 1 .005”
25 54 80 250 1 .005”
30 45 80 250 1 .005”
35 39 80 250 1 .005”
40 34 80 250 1 .005”
45 30 80 250 1 .005”
50 27 80 250 1 .005”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 40 4.0 250 1 .005”
20 30 4.0 250 1 .005”
25 24 4.0 250 1 .005”
30 20 4.0 250 1 .005”
35 17 4.0 250 1 .005”
40 15 4.0 250 1 .005”
45 13 4.0 250 1 .005”
50 12 4.0 250 1 .005”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 100 3.2 200 1 .050”
20 75 3.2 200 1 .050”
25 60 3.2 200 1 .050”
30 50 3.2 200 1 .050”
35 43 3.2 200 1 .050”
40 38 3.2 200 1 .050”
45 33 3.2 200 1 .050”
50 30 3.2 200 1 .050”
COMMENTS
Mat board (thick cardboard) is an excellent material to use for architectural modeling and for
picture framing. It cuts and engraves very neatly and cleanly. It comes in a variety of shades
and colors. Patterns can be engraved on the surface with a power setting for light engraving
which just breaks through the very thin top layer and exposes the lighter colored underlying
substrate. When engraving, a low PPI setting is used to prevent overexposure of the underlying
substrate material, which causes excessive dark discoloration. Masking is not necessary on the
top surface when engraving. When cutting, both sides might need to be masked and the
material elevated above the engraving table. This will produce an extremely clean edge on both
sides of the material.