Filter
Top Products
$)./''/$*)
+*2 -21 V
/$"2 '$)"
(Figure A.7)
Tig uses Electrode Negative Polarity so for this appli-
cation, connect the Tig torch to the negative (-) output
stud and connect the work clamp to the positive (+)
output stud. The TIG torch gas connection should be
connected to the POWER WAVE® C300’s internal
gas supply connection. If required a foot amptrol can
be connected to the remote control receptacle.
.(22 '$)"
Most SMAW welding procedures use Electrode
Positive welding. For these applications, connect the
stick electrode holder to the positive (+) output stud
and connect the work clamp to the negative (-) output
stud.
Some SMAW welding procedures use Electrode
Negative Polarity. For these applications, connect the
stick electrode holder to the negative (-) output stud
and connect the work clamp to the positive (+) output
stud.
1
2 PIN CONNECTOR
TO REMOTE CONTROL
RECEPTACLE
GAS SUPPLY
CONNECTION
TO GAS SUPPLY
CONNECTION
GAS HOSE
TIG TORCH
WORK PIECE
POWER CABLE
WORK CLAMP
FOOT AMPTROL
(OPTIONAL)
POSITIVE
STUD (+)
TO POSITIVE
STUD (+)
NEGATIVE
STUD (-)
TO NEGATIVE
STUD (-)
4 PIN GUN TRIGGER
CONNECTOR
1
2 PIN CONNECTOR
TO REMOTE CONTROL
RECEPTACLE
GAS SUPPLY
CONNECTION
TO GAS SUPPLY
CONNECTION
GAS HOSE
TIG TORCH
WORK PIECE
POWER CABLE
WORK CLAMP
FOOT AMPTROL
(OPTIONAL)
POSITIVE
STUD (+)
TO POSITIVE
STUD (+)
NEGATIVE
STUD (-)
TO NEGATIVE
STUD (-)
4 PIN GUN TRIGGER
CONNECTOR
!$"0-