Filter
Top Products
*+ -/$*)
0'+-* 0- ( (*-4+) '
*+ -/$*)
The Dual Procedure/Memory Panel performs three
functions:
U2;B:FHE9;:KH;I;B;9J?ED
U(;CEHOI7L;7D:H;97BB
U'?C?JII;JJ?D=
There are two procedure memories ( and ) and
eight user memories (1-8).
+HE9;:KH;(;CEHOLI0I;H(;CEHO
Procedure memory is used while welding. Changes to
the weld procedure (WFS, voltage, UltimArc™
Controll, etc.) immediately change the contents inside
the selected procedure memory.
User memories work by copying the weld procedure
from one of the eight memories into either the “A ” or
“B” procedure. Weld procedures are saved into the
memories only when the operator chooses.
0I?D=+HE9;:KH;(;CEH?;I
Procedure memories can be selected by choosing
either "A" or "B" procedure directly with the memory
panel, or by selecting "GUN" and using a dual proce-
dure gun to select between procedure "A" and "B".
When selecting procedures with the gun switch, "A" or
"B" will flash to show which procedure is active.
0. -( (*-$ .
Recall a memory with memory buttons
To recall a user memory, press one of the eight user
memory buttons. The memory is recalled when the
button is released. Do not hold the button for more
than two seconds when recalling a user memory.
-;97BB7C;CEHOM?J>J>;=KDJH?==;H
If desired, memories 1 through 8 can be recalled with
the gun trigger. For example, to recall memory 3,
quickly pull and release the gun trigger 3 times without
welding. To recall memory 1, quickly pull and release
the gun trigger 9 times without welding. Note: the wire
feeder is factory set with this feature disabled. Use
the SETUP menu and change P.4 to enable memory
recall with the gun trigger.
.7L;7C;CEHOM?J>C;CEHO8KJJEDI
To save a memory, press and hold the desired memo-
ry button for two seconds. When the button is initially
pressed, the corresponding LED will illuminate. After
two seconds, the LED will turn off. Do not hold the
button for more than 5 seconds when saving a user
memory.
Note that memories may be locked with weld manager
software to prevent accidental overwrite of the memo-
ries. If an attempt is made to save a memory when
memory saving is locked, the message "Memory save
is Disabled!" will appear briefly in the MSP4 display.
-;97BB?D=7C;CEHO
To recall the selected memory, press and quickly
release the center knob. After recalling a memory, a
message will briefly appear indicating that the select-
ed memory has been recalled. The Memory LED will
remain lit so that the user can quickly recall a different
memory if needed.
+*2 -21 V
A
GUNB
1
5
2
6
3
7
4
8
M
M
A
GUN B
1
5
2
6
3
7
4
8
M
M
A
GUNB
1
5
2
6
3
7
4
8
M
M
A
GUN B
1
5
2
6
3
7
4
8
M
M
PROCEDURE
MEMORY
USER
MEMORIES
ARE COPIED TO
PROCEDURE
MEMORY
(8) USER
MEMORIES
A
GUNB
1
5
2
6
3
7
4
8
M
M
A
GUN B
1
5
2
6
3
7
4
8
M
M
PRESS
TO SELECT
PROCEDURE
RECALL:
PRESS
1 SECOND
SAVE:
PRESS
2 SECONDS