Filter
Top Products
F-15
TROUBLESHOOTING & REPAIR
F-15
POWER-ARC 4000
9. Reinstall the brush holder assembly
after the test. Depress the spring-
loaded brushes into the holder and
slip a suitable non-metallic, fairly
stiff retainer through the slots at the
top and bottom of the holder. A
cable tie works well; see Figure F.3.
This will hold the brushes up so that
you can easily install the holder.
10. Slip the holder into position in the
generator end bracket. Be careful
not to loosen the 2 attached wires.
11. Reinstall and tighten the 2 screws
with the 1/4” nut driver.
12. Slowly remove the non-metallic
retainer from the brush holder and
let the brushes snap back against
the slip rings.
13. Snap the brush holder cover back
into position.
ROTOR RESISTANCE TEST (continued)
FIGURE F.3 - BRUSHES RETAINED WITH CABLE TIE
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
CABLE
TIE
BRUSHES