Filter
Top Products
STACKING
Classic III and Classic IIID machines CANNOT be
stacked.
TILTING
Place the machine on a secure, level surface whenev-
er you use it or store it. Any surfaces you place it on
other than the ground must be firm, non-skid, and
structurally sound.
The engine is designed to run in a level position for
best performance. If you do operate it at a slight angle,
be sure to check the oil regularly and keep the oil level
at the FULL mark as it would be in its normal level con-
dition. Also, fuel capacity will be a little less at an angle.
LIFTING
The Classic III weighs 1406 lb./638 kg. The Classic IIID
weighs 1445 lb./657 kg. A lift bail is provided for lifting
with a hoist.
FALLING EQUIPMENT can
cause injury.
Do not lift this machine using the lift bail
if it is equipped with a heavy accessory
such as a trailer.
Lift only with equipment of adequate
lifting capacity. Be sure the machine is stable when lift-
ing.
HIGH ALTITUDE OPERATION
It may be necessary to derate welder output at higher
altitudes. Some engine adjustment may be required.
Contact a Continental Service Representative.
PRE-OPERATION ENGINE SERVICE
Read and understand the information about the engine
in the
Operation
and
Maintenance
sections of this
manual before you operate the Classic III or Classic
IIID.
Keep hands away from the engine muffler or HOT
engine parts.
• Stop the engine when fueling.
• Do not smoke when fueling.
• Remove the fuel cap slowly to release pressure.
• Do not overfill the fuel tank.
• Wipe up spilled fuel and allow the fumes to clear
before starting the engine.
• Keep sparks and flame away from the fuel tank.
OIL
The Classic III and Classic IIID are shipped
with the engine filled with SAE 10W-30 oil.
This should be fine for most ambient oper-
ating temperature conditions. See the engine opera-
tion manual for specific recommendations. CHECK
THE OIL LEVEL BEFORE YOU START THE ENGINE.
This is an added precaution. When full, the oil level
should be up to but not over the FULL mark on the dip-
stick. If it is not full, add enough oil to fill it to the full
mark. DO NOT overfill.
For more oil fill and service information, see the
Maintenance
section of this manual.
FUEL
Fill the fuel tank with the grade of fuel rec-
ommended in the engine operation manual.
The Classic III and Classic IIID have a 15
gallon (57 liter) fuel tank with a top fill and fuel gauge
mounted on the control panel. See the
Operation
and
Maintenance
sections of this manual for more details
about fuel.
BATTERY CONNECTIONS
The Classic III and Classic IIID are shipped
with the negative battery cable disconnected. Before
you operate the machine, make sure the IGNITION
switch is in the OFF position and attach the discon-
nected cable securely to the battery terminal. If the
battery is discharged and won't start the engine, see
the battery charging instructions in the
Maintenance
section.
INSTALLATION
A-4 A-4
Classic III and IIID
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
WARNING
WARNING