Filter
Top Products
OM-203 185 Page 12
4-7. Connecting External Device
The IH/TS must have (as a
minimum) one thermocouple
connected to receptacle TC1. If
multiple thermocouples are
desired, either use individual
thermocouple plugs or the
thermocouple extension cable.
To connect thermocouples to the
control, proceed as follows:
Turn Off power source.
1. Temperature Controller
2. Thermocouple Receptacles
3. Individual Thermocouple Plug
4. Thermocouple Extension
Cable
Align plug pins with receptacle
sockets and push plug into
receptacle.
5. Coolant Line From Coil
6. Coolant Line To Cooler
“Coolant In” Port
The IH/TS is supplied with an
internal coolant flow switch.
Coolant hoses must be connected
to the IH/TS for proper operation.
Connect coolant hoses (supplied
with post-heat systems) to coolant
fittings on unit as described in
Section 4-5.
Ref. 803 003-B
Tools Needed:
11/16 in
1
2
3
4
5
6