Panasonic 35 Work Light User Manual


 
Operation modes
14
How to operate the controller
1) Setting irradiation conditions
Setting the irradiation intensity and irradiation time separately for each of CH1 to CH4.
The
TheThe
The
displayed
displayeddisplayed
displayed
values
valuesvalues
values
apply
applyapply
apply
to
toto
to
the
thethe
the
flashing
flashingflashing
flashing
channel.
channel.channel.
channel.
1. Selecting channels
Select the channel to be set by pressing CH1 to CH4. The selected
channel is indicated by a green light (flashing or still).
* It is not possible to select a CH unless an LED head is connected to it.
2. Setting irradiation intensity
Hold down the SET switch to select the CH to be set. (The selected
channel is indicated by a green light.) Initially, only “%” (intensity)
appears in the green (7-seg) display. Use △/▽ to set the desired
intensity value, then press SET again to confirm. Note that while setting
the irradiation intensity you can press the EMISSION switch to start UV
irradiation. This makes it easy to make adjustments.
3. Setting irradiation intensity
When you have finished setting the intensity, the green display will
automatically display only “sec.” Use △/▽ to set the desired time
value, then press the SET switch again to confirm. Note that if you use
to decrease the setting below “0.0 sec” the display will show “Con.”
At this setting irradiation will be continuous with no time limit.
4. Completing settings
After setting irradiation time and pressing SET the controller will return
to Operation mode. To continue settings for other channels, repeat the
procedure above from step 1 for each channel you wish to set.
(It is possible to switch the display even during irradiation. The
displayed values are stored in memory even when the controller is
powered off. After the controller is powered on again it will restore the
display to its last state. Note, however, that unless a channel is selected
nothing will be appeared on the display.)
2) Timer irradiation
Irradiation using the EMISSION switch of the controller
The
TheThe
The
displayed
displayeddisplayed
displayed
values
valuesvalues
values
apply
applyapply
apply
to
toto
to
the
thethe
the
flashing
flashingflashing
flashing
channel.
channel.channel.
channel.
(1) Starting irradiation 1. Select the channel/s for irradiation.
2. Press the EMISSION switch
(Irradiation will start on all the active channels (green indicator).
The EMISSION switch glows red during irradiation.)
* Irradiation stops after irradiation is finished on all ch
annels.
(2) Stopping irradiation 3. While irradiation is in progress press the EMISSION switch again.
(Irradiation will stop on all channels.)