Filter
Top Products
About the book
This document describes how several Schneider Electric drives type
LXM32 can share a common DC bus.
This application note replaces application note MNA01D001.
The information provided in this document supplements the manuals.
Before beginning, fully read and understand the manuals of the prod-
ucts used.
Source manuals The latest versions of the manuals can be downloaded from the Inter-
net at:
http://www.schneider-electric.com
Work steps If work steps must be performed consecutively, this sequence of steps
is represented as follows:
■
Special prerequisites for the following work steps
▶
Step 1
◁
Specific response to this work step
▶
Step 2
If a response to a work step is indicated, this allows you to verify that
the work step has been performed correctly.
Unless otherwise stated, the individual steps must be performed in the
specified sequence.
Making work easier Information on making work easier is highlighted by this symbol:
Sections highlighted this way provide supplementary information on
making work easier.
SI units Technical data are specified in SI units. Converted units are shown in
parentheses behind the SI unit; they may be rounded.
Example:
Minimum conductor cross section: 1.5 mm
2
(AWG 14)
Glossary Explanations of special technical terms and abbreviations.
Index List of keywords with references to the corresponding page numbers.
LXM32
About the book
Common DC bus 11
MNA01M001EN, V1.01, 08.2014