Filter
Top Products
For Machines Mfg. Since 8/09 Model SB1027
-29-
OPERATION
Head Movement
The mill head tilts 45° back and forth,
and rotates 90° left and right, as shown in
Figures 23–24.
Figure 24. Head tilts 90° left-and-right.
90°
Figure 23. Head tilts 45° back-and-forth.
45°
Tool Needed Qty
Wrench 19mm .......................................................1
Tilting Head
1. DISCONNECT MILL FROM POWER!
2. Loosen the three tilt lock bolts on the right
side of the ram adapter shown in Figure 25.
3. Use one hand to apply pressure to the head
in the direction of the tilt, then slowly rotate
the tilt bolt. Rotating this bolt clockwise will
tilt the head back.
4. When the head is in the correct position
for your operation, re-tighten all three lock
bolts.
Always lock the head firmly in place after
tilting or rotating it. Unexpected movement
of the head during operations could cause
damage to the cutter or workpiece.
Figure 25. Head tilting controls.
Lock Bolts
Tilt Bolt
!