Filter
Top Products
-32-
For Machines Mfg. Since 8/09
Model SB1027
OPERATION
Figure 30. Parallel block positioned for the Y-axis
measurement (top view).
Parallel Block
Indicator
Spindle
Table (Top View)
10. Rotate the spindle so that the indicator point
rests on the parallel bar, as illustrated in
Figure 30, then zero the dial.
11. Rotate the spindle so that the indicator point
rests on the other end of the bar in the same
manner, then read the dial.
— If the indicator dial still reads zero or
is within the acceptable variance, the
spindle is precisely perpendicular to the
table in both the X- and Y-axes and the
tramming procedure is complete.
— If the indicator dial has moved from zero
beyond the acceptable variance, you will
need to compensate for that amount by
tilting the head forward or back. Repeat
Steps 9–10 until you are satisfied with
the spindle axis alignment along the table
Y-axis.
Note: Keep one of the tilt lock bolts snug so
that the head does not move loosely while
you adjust it small amounts.
12. Re-tighten the tilt lock bolts.
Note: It is a good idea to repeat Steps 9-10 again
in case the head moved slightly during the
process of re-tightening the lock bolts.
9. Place the parallel block directly under the
spindle and across the width of the table, as
illustrated in Figure 30.
Note: Generally, the goal in the next steps is to
get the difference of the indicator readings
between the end of the parallel bar down to
0.0005". However, the acceptable variance
will depend on the requirements for your
operation.
6. Rotate the spindle by hand so that the
indicator point rests on one end of the
parallel block, as illustrated in Figure 29,
then zero the dial.
7. Rotate the spindle so that the indicator point
rests in the same manner on the other end of
the block, then read the dial.
— If the indicator dial still reads zero or is
within the acceptable variance, continue
on with Step 8.
— If the indicator dial has moved from zero
beyond the acceptable variance, you will
need to compensate for that amount by
rotating the head left or right. Repeat
Steps 5–6 until you are satisfied with the
spindle axis alignment along the table
X-axis.
Note: Keep one of the rotation lock bolts
snug so that the head does not move
loosely while you adjust it small amounts.
8. Re-tighten the rotation lock bolts.
Note: It is a good idea to repeat Steps 5-6 again
in case the head moved slightly during the
process of re-tightening the lock bolts.