Filter
Top Products
-18-
For Machines Mfg. Since 5/11
13" x 40" Heavy 13
®
EVS Lathe
PREPARATION
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Inventory
Main Inventory 1: (Figure 9) Qty
A. Steady Rest Assembly (Installed) .................1
B. 10" Faceplate w/D1-5 Camlock Stud Set ......1
C. 8" 4-Jaw Chuck w/Combo Jaws (SB1226) ....1
D. 3-Jaw Chuck Key ...........................................1
E. 4-Jaw Chuck Key ...........................................1
F. Follow Rest Assembly (Installed) ..................1
Tool Box Inventory: (Figure 10) Qty
G. Tool Box ..........................................................1
H. Open End Wrench 22/24mm .........................1
I. Open End Wrench 14/17mm .........................1
J. Open End Wrench 10/12mm .........................1
K. Phillips Screwdriver #2 .................................1
L. Standard Screwdriver #2 ...............................1
M. Hex Wrench 8mm ..........................................1
N. Carbide-Tipped Dead Center MT#3 ..............1
O. Tapered Spindle Sleeve MT#5-#3 .................1
P. Dead Center MT#3 .........................................1
Q. Camlock Key D1-5 .........................................1
R. Tool Post T-Wrench (Clamped on Tool Post) 1
S. Hex Wrench 10 Pc. Set 1.5-10mm .................1
T. Carriage Handwheel Handle .........................1
U. Cross Slide Handwheel Handle .....................1
V. Cast Iron Leveling Pads ................................6
Installed & Not Shown Qty
s 7" 3-Jaw Chuck w/Combo Jaws (SB1308) ....1
s 8
1
⁄4" Back Plate D1-5 (SB1399) ......................1
Figure 9. Main inventory.
A
B
C
D
E
F
Figure 10. Toolbox inventory.
G
Q
R
S
P
N
O
H
I
J
K
L
M
V
U
T
Some inventory components may be shipped
inside the lathe electrical box or attached to
the tool post. Inventory items in the electrical
box MUST be removed before connecting the
lathe to the power source.