Filter
Top Products
-4-
For Machines Mfg. Since 5/11
13" x 40" Heavy 13
®
EVS Lathe
INTRODUCTION
General Identification
Serious personal injury could occur if
you connect the machine to power before
completing the setup process. DO NOT
connect power until instructed to do so later
in this manual.
Untrained users have an increased risk
of seriously injuring themselves with this
machine. Do not operate this machine until
you have understood this entire manual and
received proper training.
Figure 1. Identification.
Q
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
A. Spindle Speed Digital Readout
B. Chuck Guard w/Safety Switch
C. 3-Jaw Chuck (7") w/2-Piece Jaws
D. Halogen Work Light
E. Compound Rest w/4-Way Tool Post
F. Coolant Nozzle & Control Valve
G. Tailstock
H. Longitudinal Leadscrew
I. Feed Rod
J. Coolant Pump & Tank Access
K. Slide-Out Chip Tray
L . Safety Brake Pedal
M. Carriage (see Page 6 for details)
N. Micrometer Stop
O. Control Panel (see Page 6 for details)
P. Quick-Change Gearbox Controls (see Page 5
for details)
Q . Headstock Controls (see Page 5 for details)