Filter
Top Products
Maintenance
6–40
THS710A, THS720A, THS730A & THS720P Service Manual
Unpacking and Repacking Instructions
This section contains the information needed to unpack the TekScope instrument
and repack it for shipment or storage.
The TekScope instrument and its standard accessories are carefully packed at the
factory in a padded case, which is enclosed in a shipping carton. If, upon receipt,
damage to the shipping carton is evident, notify the shipper. Tektronix, Inc. is
not responsible for damage caused during shipping.
If you have not already done so, carefully remove the TekScope instrument and
its accessories from the padded case and inspect them for damage. Save the
shipping carton for repacking or storage.
Use a corrugated cardboard shipping carton having a test strength of at least
275 pounds (125 kg) and with an inside dimension at least six inches (15.25 cm)
greater than the instrument dimensions.
If the instrument is being shipped to a Tektronix Service Center, enclose the
following information:
H The owner’s address
H Name and phone number of a contact person
H Type and serial number of the instrument
H Reason for returning
H A complete description of the service required
Seal the shipping carton with an industrial stapler or strapping tape.
Mark the address of the Tektronix Service Center and also your own return
address on the shipping carton in two prominent locations.
The TekScope instrument should be stored in a clean, dry environment. The
following environmental characteristics apply for both shipping and storage
(instrument not operating):
H Temperature range: –20° C to +60° C
H Altitude: To 15,000 m
See the chapter Specifications for a complete listing of the environmental
charactertistics.
Unpacking
Repacking
Storage