Filter
Top Products
Maintenance
THS710A, THS720A, THS730A & THS720P Service Manual
6–21
Install foam pads
Install foam pads
Install foam pad
Install foam pad
Install I/O port
hole plug
Install DC power
hole plug
Figure 6–12: Foam pad and hole plug locations on the back cover
c. Place the back cover on a soft surface with the BNC connector openings
facing away from you.
d. Dress the battery wires to the left side of the back cover to provide
clearance for the chassis.
e. While inserting the BNC connectors into their openings, lower the
chassis into the back cover.
f. Reconnect the battery wire connector and press it onto its retaining pins.
Check that the polarity of the connector is correct. Dress the wires into
the channel on the chassis as shown in Figure 6–13.
3. Install the switch mat and front cover using the procedure on page 6–12.