Filter
Top Products
NDIR Gas Analyzer Specifications
Teledyne Analytical Instruments 107
note1) When “D” is specified at 4th digit, Power supply cord is supplied
in the scope of supply. Cord specification should be specified at
the 20th digit.
note2) When only O2 measurement is necessary, “Y” should be
specified at 6th digit.
note3) When “1” is specified at 7th digit, O2 pt analyzer signal has to be
set as 0-1V DC linear corresponding to full scale.
External zirconia O2 analyzer and external O2 analyzer are not
included in the scope of supply, and has to be separately ordered.
note4) Refer to Table 1 for possible combination of measuring
components and ranges in this manual. When “Y” is specified at
6th digit, “Y” should be specified at 9th to 16th digit. For fuel
cell O2 analyzer, range is 0-10vol% or more.
note5) Select the type of voltage rating, plug type and applicable
standard of the power supply cord by 20th digit. Select a power
supply cord for using at the location of end-user. When “A” is
specified at 4th digit, Power supply cord will not be included in
scope of delivery. When English is specified for display
language, “E” should be selected at 20th digit.
note6) O2 correction is calculated only for NO, SO2 and CO.
note7) When 5 components measurement is specified, “H” must not be
specified at 22nd digit.