Filter
Top Products
Rev. B
Workman 200 Spray System Page 3 -- 3 Spray System
General Information
Precautions Concerning Chemicals Used in Spray System
Chemicals can injure persons, animals, plants, soil, or
other property. To eliminateenvironmental damage and
personal injury:
1. Select the proper chemical for the job.
2. Carefully read thedirections printed on the chemical
manufacturer’s labels before handling c hemicals. In-
structions on chemical manufacturer’s container labels
regarding mixingproportions shouldbe readand strictly
followed.
3. Keepspraymaterialawayfromskin.Ifspraymaterial
comes in contact with a person, wash it off immediately
in accordance with manufacturer’s recommendations
(container labels and Material Safety Data Sheets).
4. Always wear protective clothing, chemical resistant
gloves, eye protection, and other personal protective
equipment as recommended by the chemical manufac-
turer.
5. Properly dispose of chemical containers, unused
chemicals, and chemical solution.
Precautions for Removing or Adjusting Spray System Components
1. Stop the vehicle and set the parking brake.
2. Shut off the vehicle’s engine and remove the key
from the ignition switch.
3. Disengage all power and wait until all moving parts
have stopped.
4. Remove chemicals from pump, hoses, and other
spray components. Thoroughly neutralize and rinse
spray system before loosening or removing any spray
system component(s).
5. Makesure line pressureis relieved beforeloosening
any system component.
O--Ring Seal Kit (Serial Numbers Below 310000000)
Part Number: 106--4846
The O--Ring Seal Kitincludes an assortment of O--rings
used for sealing the spray control valves on Workman
sprayers with serial numbers below 310000000. It is
recommended that O--rings be replaced every two (2)
years or whenever a v alve is loosened.
Figure 1
SPRAYER
O--RING SEAL KIT
PART NO. 106--4846
Spray
System