Filter
Top Products
Turret Body Service
Disassembly (Fig. 42)
1. Pull e–clip from body and slide plug with o–ring from
body.
2. Disassemble turret body using Figure 42 as a guide.
3. Discard all removed seals, gaskets, o–rings, and di-
aphragms.
Assembly (Fig. 42)
NOTE: Coat all o–rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Replace all removed seals, gaskets, o–rings, and di-
aphragms.
2. Assemble turret body using Figure 42 as a guide.
A. The turret (item 8) end with slightly larger bore
and detent grooves needs to be orientated toward
detent posts on body (item 4) (Fig. 43).
B. Make sure to align notch on plug (item 10) with
groove in body (item 4) as plug is installed.
C. Install e–clip (item 5) into body to secure assem-
bly.
1
2
3
6
4
5
11
10
12
14
13
15
8
7
9
17
16
18
6
Figure 42
1. Upper clamp
10. Plug
2. O–ring
11. Nozzle
3. Pivot pin
12. Nozzle cap
4. Body
13. O–ring
5. E–clip
14. Seal
6. Gasket (3 used)
15. Screw
7. Dust cap (2 used)
16. End cap
8. Turret
17. Diaphragm
9. O–ring
18. Hose barb
Spray
System
2
1
3
2
Figure 43
1. Body 3. Detent groove
2. Detent post
Workman 200 Spray System
Page 3 – 39
Spray System