Filter
Top Products
Maintenance and Service
1. Before servicing or making adjustments, turn PTO
off, put shift lever in neutral, stop engine, set parking
brake, and remove key from the switch.
2. Prior to servicing sprayer components, determine
what chemical(s) have been used in the sprayer. Follow
precautions and recommendations printed on chemical
container labels or Material Safety Data Sheets when
servicing sprayer components. Use appropriate protec
-
tive equipment: protective clothing, chemical resistant
gloves, and eye protection.
3. Make sure machine is in safe operating condition by
keeping all nuts, bolts and screws tight.
4. Never store the machine or fuel container inside
where there is an open flame, such as near a water heat
-
er or furnace.
5. If major repairs are ever needed or assistance is de-
sired, contact an Authorized Toro Distributor.
6. If engine must be running to perform maintenance or
an adjustment, keep clothing, hands, feet, and other
parts of the body away from moving parts. Keep by
-
standers away.
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the Workman 200 Spray System. If any decal becomes
illegible or damaged, install a new decal. Part numbers
are listed in your Parts Catalog. Order replacement de-
cals from your Authorized Toro Distributor.
Product Records
Insert Operator’s Manual, Installation Instructions and
Parts Catalog for your Workman 200 Spray System at
the end of this Chapter. Refer to Operator’s Manual for
recommended maintenance intervals. Additionally, in
-
sert Installation Instructions, Operator’s Manuals, and
Parts Catalogs for other accessories (e.g. Foam Mark
-
ing Kit, Hose Reel Kit) that have been installed on your
Workman vehicle at the end of this Chapter.
7. Disconnect battery before servicing the machine.
Disconnect negative (–) battery cable first and positive
(+) cable last. If battery voltage is required for trouble-
shooting or test procedures, temporarily connect the
battery. Reconnect positive (+) cable first and negative
(–) cable last.
8. Battery acid is poisonous and can cause burns.
Avoid contact with skin, eyes, and clothing. Protect your
face, eyes, and clothing when working with a battery.
9. Battery gases can explode. Keep cigarettes, sparks,
and flames away from the battery.
10.To assure optimum performance and continued
safety of the machine, use genuine Toro replacement
parts and accessories. Replacement parts and acces
-
sories made by other manufacturers may result in non-
conformance with safety standards, and the warranty
may be voided.
Safety and
Product Records
Workman 200 Spray System Page 1 – 3 Safety and Product Records