Filter
Top Products
Adjustment
1. Loosen end nut that secures adjustable clevis to
boom frame (Fig. 51). Position jam nut as close as pos
-
sible to adjustable clevis. Tighten end nut to secure cle-
vis.
2. Fully raise side boom with the boom actuator. The
boom actuator should fully extend and ratchet.
3. With the boom actuator at full extension, the break-
away pivot gusset should just touch the center boom
frame slot (Fig. 52).
4
3
2
1
4. If needed, loosen end nut that secures adjustable
clevis and readjust jam nut on clevis to allow correct
Figure 51
1. Boom actuator 3. Jam nut
boom actuator extension. Tighten end nut to secure cle-
vis adjustment.
2. Adjustable clevis 4. End nut
3
2
1
Figure 52
1. Breakaway pivot gusset 3. Boom actuator
2. Boom frame slot
Spray
System
Workman 200 Spray System
Page 3 – 45
Spray System