Filter
Top Products
Workman 200 Spray System
Page 3 – 38
Spray System
Turret Bodies
1. Turret body (w/90
o
elbow)
2. 90
o
elbow (1 used)
3. Screw
4. Turret body (w/double hose barb)
5. Turret body (w/single hose barb)
6. Single hose barb (3 used)
7. Double hose barb (7 used)
8. Turret body clamp
9. Hose barb (for 90
o
elbow)
Figure 41
7
2
8
3
9
4
5
RIGHT
6
1
BOOM
SUPPLY
CENTER
BOOM
SUPPLY
LEFT
BOOM
SUPPLY
5
4
4
4
5
5
4
4
4
4
1
3
3
Removal (Fig. 41)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves, and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Loosen hose clamp(s) and remove supply hose(s)
from turret body.
3. Remove screw that secures turret body clamp to
spray boom. Separate clamp halves and remove turret
body from machine.
Installation (Fig. 41)
NOTE: The type of hose barb on turret body deter-
mines turret location on spray boom. Refer to Figure 41
for turret position on booms.
1. Position turret body clamp halves to spray boom and
turret body. Slide clamp halves together. Position turret
so that spray nozzle and nozzle fan slot are parallel to
ground. Tighten clamp screw to secure turret body.
2. Install supply hose(s) to turret body. Tighten hose
clamp(s).