Wagner SprayTech 2309 518 Paint Sprayer User Manual


  Open as PDF
of 32
 
43
Plast Coat 430
GB
6.3 CONNECTING THE MORTAR HOSE
• Checkthatthepumpunitisseatedrmly.
• Connect the mortar hose (Fig. 7, 1) and secure it with the
clamping levers (Fig. 7, 2).
• Connect the atomizing air connection at the mortar hose
tothecompressedairsupply,forexamplethecompressor
(accessory).
2
1
6.4 COMPRESSOR ACCESSORY
Place the compressor at a secure location next to the mortar
sprayingmachineandconnectittothemainsnetwork.
Note:
Onlyoperatethecompressorinaccordancewiththeenclosed
operating manual.
6.5 CONNECTING THE SPRAY LANCE FIG. 10
• Mountthetexturetip(1)inthespraylancewiththecone
pointingtowardsthesprayhead.
The tip size should amount to at least three times the
granular size,
e.g. granular size Articial resin plasters –> 3 mm
Tip size –> 10 mm
• Connectthespraylance(2)andsecureitwiththeclamping
levers (3).
• Close the material tap (4) (material tap at 90° to spray
lance).
• Screwcouplingplug(5)forremotecontroltothecontrolca-
ble of the mortar hose.
• Connectatomizationairconnection(6)totheairhoseofthe
mortar hose.
• Connectmortarhose‘scontrolcabletobottompumpcon-
nection. (Fig. 11)
• Setselectorswitchto“A”.
6.3. CONNECTING THE MORTAR HOSE
• Checkthatthepumpunitisseatedrmly.
• Connectmortarhose(Fig.7,1)toreductionpieceandse-
cure with clamping levers (Fig. 7, 2).
• Connectatomisingairconnectiononmortarhosetofront
connection on handle (Fig. 8,1) and compressor air hose (ac-
cessory)torearconnectiononhandle(Fig.8,2).
1
2
6.4 COMPRESSOR ACCESSORY
Place the compressor at a secure location next to the mortar
sprayingmachineandconnectittothemainsnetwork.
Note:
Onlyoperatethecompressorinaccordancewiththeenclosed
operating manual.
6.5 CONNECTING THE SPRAY LANCE FIG. 12
• Selectaspraytipsuitableforthematerial:
Type of material Tip colour
Fine grain 3 mm (blue)
4 mm (red)
5mm(yellow)
Coarse grain 6 mm (black)
7 mm (green)
8 mm
10 mm
12 mm
The tip size should amount to at least three times the
granular size,
e.g. granular size Articial resin plasters –> 3 mm
Tip size –> 10 mm
• Inserttip(1)atfrontinspraylance(2)andsecurewithring
(3).
• Fitspraylancewithreductionpiece(4)onmortarhose(5)
and secure with clamping levers (6).
• Closematerialtap(7)(facingtotherear)
• Coupleatomisingairconnection(8)toairhoseonmortar
hose.
• Setselectorswitchto“A”.
AUTOMATIC SPRAY LANCE PNEUMATIC SPRAY LANCE
commIssIonIng
 previous next