Wagner SprayTech 2309 518 Paint Sprayer User Manual


  Open as PDF
of 32
 
52
Plast Coat 430
GB
Ifthedefectisnotcausedbyoneoftheabove-mentionedfaults,havethedefecteliminatedbytheWAGNERcustomerservice.
malfunctIon possIble cause elImInatIon
Pressure at the manometer rises
to more than 40 bars.
Viscosityofthecoatingmaterialtoo
high.
Mortar hose diameter too small.
Mortar hose is too long.
Coating material “plug” in the mortar
hose. Mortar hose not prerinsed with
cellulose paste.
Dilute the coating material.
Use a mortar hose with a larger diameter.
Use a shorter mortar hose.
Depressurize the mortar hose – set the selector
switch to “R” (reverse).
Pump the coating material back into the con-
tainer.
The mortar hose must be pres-
sureless.
Watch the manometer ––> 0 bar.
Wear safety goggles.
Decouple mortar hose and rinse with water hose.
When the plug has been removed, ll cellulose
paste in the mortar hose. Couple the mortar hose
back on.
Mortarsprayingmachinedoes
not pump enough coating ma-
terial.
Conveycapacityselectedtoolow.
Mortar hose diameter too small.
Stator worn.
Texture tip too small.
Set the volume regulator higher.
Use a mortar hose with a larger diameter.
Mountanewstator,ifnecessary,alsoanewrotor.
Attention: Sprayonpumpslidingmeans.
Select a larger texture tip.
Rule of thumb: Granular size x 3 ––> Tip size
Coating material is emitted at
the inspection hole (1).
1
The shaft seal that seals between the
pump unit and the drive unit is worn.
Stopworkimmediatelybecauseotherwisecoat-
ingmaterialmayenterthedriveandresultina
defect.
Clean machine and contact Wagner customer
service.
elImInatIng faults
 previous next