Wagner SprayTech 2309 518 Paint Sprayer User Manual


  Open as PDF
of 32
 
48
Plast Coat 430
GB
Cleaning the pump unit
Once the pump pipe has been removed from the pump unit,
the pump housing (10) up to the seals can be cleaned with a
jet of water and suitable bottle brush.
Thoroughlycleanrotor(11),stator(9)andpumppipe(8)with
waterandabrushtooifnecessary.
Thensprayrotor(11)andstator(9)withasuitablepumplu-
bricant.
Keep the thread of the pump housing and the pump tube
cleansothatleakingaftertheassemblyisavoided.
Dismantling
Mortar spraying machine must be depres-
surised.
If necessary, set the selector switch briey
to “R” (reverse).
Watch the manometer ––> 0 bar.
Wear safety goggles.
Onlythepersonoperatingthemachinemay
remove the pump unit.
• Moveselectorswitch(1)to“A”andsetdeliveryvolumecon-
troller (2) to „0“.
• Pullsafetypin(3)toreartoreleaselock.PullPC430upbyits
frame (4) until the machine engages in the top position.
• Loosen the union nut on the pump tube using the special
key(approx.aone-quarterturn)
• Removenutsfromlockingpins(5).Folduplockingpinsso
thattheyremainincontactwithmagnetsinhandle.
• Setdeliveryvolumecontroller(2)to1or2.
• Firmly hold pump unit (6) with one hand. Move selector
switch (1) to “R” position (reverse gear) and hold there. As
soon as the pump unit (6) has released, move selector switch
to “A” and remove pump unit.
• Disconnect mains plug.
• Loosen/unscrewpump pipe(8)from pumpunit (6)using
thespecialkeyprovided.
• Removestator(9)frompumppipe.
shuttIng Down anD cleanIng
Mounting
Insert stator (9) in pump pipe (8) such that the journal sits in
the largest recess.
Usespecialkeytoscrewpumppipebackontopumpunit(6).
6
9
8
A
F R
POWER
ERROR
1
4
3
11
A
F
R
POWER
ERROR
2
5
6
10
 previous next