Wagner SprayTech 2309 518 Paint Sprayer User Manual


  Open as PDF
of 32
 
39
Plast Coat 430
GB
4.3 COMPRESSOR ACCESSORY
VKM 592 intake volume 590 l/min
Note:
Onlyoperatethecompressorinaccordancewiththeenclosed
operating manual.
4.4 MORTAR HOSE FOR PNEUMATIC SPRAY LANCE
1 Materialconnectionmortarsprayingmachine
2 Atomizingairconnectioncompressedairsupply
3 Materialconnectionspraylance
4 Mortar hose
5 Atomizingairconnectionspraylance
2
1
5 4
3
4.5 PNEUMATIC SPRAY LANCE
1 Atomizing air connection
2 Texture tip
3 Combined material and air tap
Open:materialtapat90°tospraylance
Closed: material tap facing to the rear
4 Material connection
Varioustexturetipscanbeusedinthespraylance.Thetipsize
depends on the granular size of the coating material and the
desiredspraypattern.
3
1
2
4
overvIew
If the selector switch is in the “F” position when
the mains plug is plugged in, the machine will not
switch on.
Brieymoveselectorswitchto“A”andthenback
to “F” to switch on the machine.
EMERGENCY STOP switch
When the EMERGENCY STOP switch is pressed, the PC 430 is
switchedoimmediately.
Turn the EMERGENCY STOP switch in order to release it again.
The machine remains switched o after release. To switch it on
again,theselectorswitchmustbebrieysetto“A”andthen
to “F”.
4.2 DRIVE
When an overload occurs, the mortar spraying machine
switchesoautomatically(redindicatorlightlightsup).
Move selector switch (Fig. 3, 2) to “A” and disconnect mains
plug.Setdeliveryvolumecontroller(Fig.3,1)to„0“.
Waitaround5minutes,thenplugthemortarsprayingmachine
backinandswitchon.Setthedeliveryvolumerequired.
The drive unit heats up during operation. This
is normal and not a sign of malfunction.
 previous next