Wagner SprayTech 2309 518 Paint Sprayer User Manual


  Open as PDF
of 32
 
50
Plast Coat 430
GB
malfunctIon possIble cause elImInatIon
Mortarsprayingmachinenot
running.
Green operating light lights up
Deliveryvolumecontrollerissetto„0“
Lance control cable not connected or
damaged
Switched to remote control operation
(Switch 6 Fig. 3 in Position “II”) but re-
mote control not connected
Increasedeliveryvolume
Check control cable
Connect a remote control or set switch (6 Fig. 3) to
Position “I”, in order to switch o operation with re-
mote control.
Mortarsprayingmachinenot
running.
Green operating light not does
not light up
Powersupplymissing. - Plug in the power plug.
- Check the power cable for damage and replace,
ifnecessary.
- Checkthepowersupply.
Mortarsprayingmachinenot
running.
Red indicator light lights up
Mortarsprayingmachinewasover-
loaded/overheated.
Close material tap and disconnect mains plug.
Switchthemortarsprayingmachineonagainafter
about 5 minutes.
Mortarsprayingmachinecan-
notbeswitchedon/oby
means of the remote control.
Remote control not on.
Remote control line not connected or
defect.
Set selector switch to “A” and set switch (Fig. 3, 6)
to position “II”, in order to activate remote control.
Connect remote control, check connections, check
remote control line for damage.
Mortarsprayingmachinecan-
not rotate the rotor
Rotor stuck in stator.
Pump was not lubricated with pump
sliding means.
Settheselectorswitchalternativelybrieyto“F”
(forwards) – “R” (reverse).
Contact Wagner customer service if the problem
cannot be resolved.
Mortarsprayingmachinebuilds
up pressure in the mortar hose.
However, coating material does
notarriveatthespraylance.
Coatingmaterial"plug"inthemortar
hose. Mortar hose not prerinsed with
cellulose paste.
Depressurize the mortar hose – set the selector
switch to “R” (reverse).
Pump the coating material back into the con-
tainer.
The mortar hose must be pres-
sureless.
Watch the manometer ––> 0 bar.
Wear safety goggles.
Decouple mortar hose and rinse with water hose.
When the plug has been removed, ll cellulose
paste in the mortar hose. Couple the mortar hose
back on.
10 ELIMINATING FAULTS
elImInatIng faults
 previous next