Wagner SprayTech 2309 518 Paint Sprayer User Manual


  Open as PDF
of 32
 
51
Plast Coat 430
GB
malfunctIon possIble cause elImInatIon
Coatingmaterialissuddenly
notemittedduringspraying.
Texture tip is clogged because of
impurityinthecoatingmaterialorbe-
cause the granular size is too large.
Texture tip too small.
Coating material “plug” in the mortar
hose. Mortar hose not prerinsed with
cellulose paste.
No coating material in the container.
Pump has sucked in air.
Switchthemortarsprayingmachineo.
Closethematerialcockatthespraylance.
Remove the texture tip and clean it.
Select a larger texture tip.
Rule of thumb: Granular size x 3 ––> Tip size
Depressurize the mortar hose – set the selector
switch to “R” (reverse).
Pump the coating material back into the con-
tainer.
The mortar hose must be pres-
sureless.
Watch the manometer ––> 0 bar.
Wear safety goggles.
Decouple mortar hose and rinse with water hose.
When the plug has been removed, ll cellulose
paste in the mortar hose. Couple the mortar hose
back on.
Top up coating material in container and pump
round until coating material exits without bub-
bles.
Attention:
Always top up with sucient coating material.
Do not let the pump run dry. Pump overheats,
resulting in a danger of „plugs“.
Spraypatternisnotcleanand
even.
Airductsinthetexturetiparepartially
closed with coating material.
Airvolumeincorrectlyset.
Poormortarsprayingmachineclean-
ing
No coating material in the container.
Pump has sucked in air.
Switchthemortarsprayingmachineo.
Closethematerialtapatthespraylance.
Remove the texture tip. Clean the air ducts of the
texture tip.
Change air volume setting.
Thoroughlycleanmortarsprayingmachine
Top up coating material in container and pump
round until coating material exits without bub-
bles.
Attention:
Always top up with sucient coating material.
Do not let the pump run dry. Pump overheats,
resulting in a danger of „plugs“.
elImInatIng faults
 previous next