Filter
Top Products
22
Mount Router Directly to the
Table
BA, black (4)
1. Remove router base plate from
router by removing screws.
2. Loosen knobs and slide fence so that
it clears mounting holes.
3. While holding router upside down,
position it underneath the table so
that the center of the router is within
the center ring of the table top.
4. Rotate router until mounting holes in
router base line up with the holes in
the table top.
WARNING
Figure 19
WOLF109-8
P
U
L
L
O
N
P
U
S
H
O
F
F
R
E
S
E
T
O
U
T
L
E
T
S
NOTE: For ease of use, position the
router so the ON-OFF switch is
accessible from the front of the table.
5. Insert router base plate screws
previously removed through holes in
table top and into router mounting
holes. Tighten securely. See Figure
19.
Make sure the screws
from your router base
plate match the countersinks in the table
and are long enough to mount the router
to the table. If necessary repace with
screws that are 1/8 to 1/4 inch longer.
Mounting Routers with Square
Adaptor Plate
Some router models will not mount
directly to this router table. For these
routers, a square adapator base plate is
provided. It will need to be modified to
fit your particular router. Once modified,
and attached to your router, it will mount
directly to the router table.
1. Cut out template on page 23. Also
cut out inner circle of template.
2. Position template on the side of
square adaptor base plate with
welded nuts.
3. Accurately line up the edges of the
template with the edges of the adaptor
base plate. Make sure inner circle
also precisely matches hole in plate.
W
A
RN
I
NG
WA
R
N
I
N
G