Filter
Top Products
Prestige 630-C Series ADSL USB Modem
Administrative Privileges 7-9
Table 7-7 Miscellaneous Configuration
LABEL DESCRIPTION
HTTP server access In this section, you can configure how from where the web configurator can be
accessed.
All
Select All to allow access from both the LAN and WAN.
Restricted LAN
Select the Restricted radio button and the LAN check box to restrict access to
the Prestige from a computer on the LAN.
Restricted WAN
Select the Restricted radio button and the WAN check box to restrict access
to the Prestige from a computer on the WAN with a specific IP address.
Specify IP Enter the IP address of the computer on the WAN that is allowed to access the
Web Configurator.
Subnet Mask Enter the corresponding subnet mask for the above IP address.
HTTP server port This field allows you to specify a port for the Web server. For example, when
set to 1001, the HTTP server address for the LAN side is http://10.0.0.2:1001,
where 10.0.0.2 is the default IP Address).
PPP disconnect on LAN
probe timeout
Select Enabled to allow the PPP session to timeout (see section 6-1). Select
Disabled to prevent disconnection due to timeout.
PPP reconnect on WAN
access
Select Enabled to have a PPP session automatically reconnect when a packet
is sent to the WAN. Select Disabled to prevent reconnection.
Submit Click this button to apply the changes.
Reset Click this button to reset all values to their defaults.
7.9 Restoring Factory Defaults
To restore the factory defaults on your Prestige, click Reset to Factory Defaults; the following screen will
appear. Click Submit to confirm.
Figure 7-8 Restore Factory Defaults