Filter
Top Products
Prestige 650 ADSL Router
11-14 Firmware and Configuration File Maintenance
11.4.8 Uploading Firmware File Via Console Port
Step 1. Select 1 from Menu 24.7 — System Maintenance — Upload Firmware to display Menu
24.7.1 — System Maintenance — Upload System Firmware, then follow the instructions as
shown in the following screen.
Figure 11-16 Menu 24.7.1 as seen using the Console Port
Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.
11.4.9 Example Xmodem Firmware Upload Using HyperTerminal
Click Transfer, then Send File to display the following screen.
Figure 11-17 Example Xmodem Upload
After the firmware upload process has completed, the Prestige will automatically restart.
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning: Proceeding with the upload will erase the current system
firmware.
Do You Wish To Proceed:(Y/N)
Choose the Xmodem protocol.
Then click Send.
Type the firmware file’s
location, or click Browse to
look for it.