Filter
Top Products
Prestige 650 ADSL Router
5-4 Remote Node TCP/IP Configuration
Figure 5-4 Remote Node Network Layer Options
The following table shows the fields in Menu 11.3 — Remote Node Network Layer Options.
Table 5-2 TCP/IP Remote Node Configuration
FIELD DESCRIPTION EXAMPLE
IP Address
Assignment
Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote
node is using a dynamically assigned IP address or Static if it is using a
static (fixed) IP address. You will only be able to configure this in the
ISP node (the first node); all other nodes are set to Static.
Static
Rem IP Addr
This is the IP address of the remote gateway. Type the remote
Prestige’s WAN IP address here (172.16.02 in the example Figure 5-3
shown previously). If the remote Prestige’s WAN IP address is 0.0.0.0,
then type 192.168.1.1 (its LAN IP address) here.
0.0.0.0
(default)
Rem Subnet
Mask
Type the subnet mask assigned to the remote node. 0.0.0.0
(default)
My WAN Addr Some implementations, especially UNIX derivatives, require separate
IP network numbers for the WAN and LAN links and each end to have a
unique address within the WAN network number. In that case, type the
IP address assigned to the WAN port of your Prestige.
NOTE: Refers to local Prestige address, not the remote router address.
NAT
Press [SPACE BAR] and then [ENTER] to select Full Feature if you
have multiple public WAN IP addresses for your Prestige.
Full
Feature
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment= Static Ethernet Addr Timeout (min)= 0
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set=2
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
IP Policies=
Press ENTER to Confirm or ESC to Cancel: