Filter
Top Products
Prestige 650 ADSL Router
Remote Node Configuration 4-1
Chapter 4
Remote Node Configuration
This chapter covers the parameters that are protocol-independent. Protocol-dependent
configuration (TCP/IP and Bridging) is covered in the following chapters.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. When you use menu 4 to set up Internet
access, you are configuring one of the remote nodes.
4.1 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1. From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
Step 2. When menu 11 appears, as shown in the following figure, type the number of the remote node
that you want to configure.