Filter
Top Products
Prestige 650 ADSL Router
2-8 Hardware Installation and Initial Setup
Figure 2-6 Power-On Display
2.7.2 Entering Password
The login screen appears after you press [ENTER], prompting you to enter the password, as shown next.
For your first login, enter the default password “1234”. As you type the password, the screen displays an
“X” for each character you type.
Please note that if there is no activity for longer than five minutes after you log in, your Prestige will
automatically log you out and will display a blank screen. If you see a blank screen, press [ENTER] to
display the login screen again.
Figure 2-7 Login Screen
2.8 Resetting the Prestige
If you forget your password or cannot access the Prestige, you will need to reload the factory-default
configuration file. Uploading this configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all configurations that you had previously and the
speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and
flow control set to none. The password will be reset to “1234” and the LAN IP address to 192.168.1.1also.
To obtain the default configuration file, download it from the ZyXEL FTP site, unzip it and save it in a
folder. Turn the Prestige off and then on to begin a session. When you turn on the Prestige again you will
see the initial screen. When you see the message “Press any key to enter Debug Mode within 3 seconds”
press any key to enter debug mode.
To upload the configuration file, do the following:
Enter Password : XXXX
Copyright (c) 1994 - 2002 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:01:23:45
HWSAR (FPGA) : programing (11969) ... done
HWSAR (FPGA) : testing . . . done
WAN Channel init . . . . done
Loading ADSL modem F/W
............................................... done
Press ENTER to continue...