A SERVICE OF

logo

Open as PDF
next previous
2 - 6 Ethernet RMON MultiProbe Module Installation and Operation Guide
Figure 2-1 shows the RMON MultiProbe Module installed in an
ONline System Concentrator. You can also install the RMON
MultiProbe Module in the ONcore MultiProtocol Switching Hub using
an ONline Module Adapter Kit.
Figure 2-1. RMON MultiProbe Module in the
ONline System Concentrator
4. Using your fingers, tighten the spring-loaded screws on the front of
the module faceplate (do not overtighten). Once you install the
RMON MultiProbe Module, it begins diagnostic testing automatically.
5. Connect one end of an RS-232 cable to the RS-232 port on the front
of the module.
6. Connect the other end of the cable to a terminal (as described in the
next section).
RMON MultiProbe Module