2 - 10 Ethernet RMON MultiProbe Module Installation and Operation Guide
Monitoring the Front Panel
Use the LEDs on the front panel of the RMON MultiProbe Module to
monitor the status of the module and the module interfaces. The RMON
MultiProbe Module front panel also contains a recessed Reset button for
resetting the module.
Resetting the module is equivalent to a warm start. Refer to Chapter 3,
Configuring the Module, the section titled Re-Initializing the RMON
MultiProbe Module for information on warm and cold starts.
When you install the RMON MultiProbe Module in the hub, an Interface
Status LED illuminates for each interface after the following conditions are
met:
❑ The RMON MultiProbe Module completes self-diagnostics and
initializes.
❑ You assign an interface to a network (the interface is enabled
automatically once you assign a network using a 3Com management
module or set the DIP switches).
The Module Status LED illuminates once the module completes
self-diagnostics and initializes (45 seconds).
