Configuring the Module 3 - 5
Modifying Configuration Menu Values
The configuration menus contain options that enable you to:
❑ Display additional configuration menus
❑ Display and modify configuration values
To display a menu from within a menu, type the number of the option and
press Return.
To display or modify a value from a configuration menu:
1. Type the number of the option you want to display or modify and
press Return. The configuration menus have a timeout value of 2
minutes. Therefore, you must enter a keystroke to a menu within 2
minutes or the following message displays and the module
automatically warm-starts.
Keyboard input timeout.
Module warm started and config system exited.
2. To modify configuration menu values, delete one character at a time
using the Backspace key. To delete the entire value, press Ctrl-U.
When you press Ctrl-U, <CANCEL> appears at the end of the current
value to verify that the current value is canceled.
3. Enter the new value and press Return.
4. Select S to save changes and exit the current menu, or 0 (zero) to
cancel changes and exit the current menu. Exiting a current menu
brings you up one menu level. When you return to the Main menu,
you must select either a warm or cold start to re-initialize the RMON
MultiProbe Module.
5. To re-initialize the RMON MultiProbe Module, select option 3 for a
warm start or select option 4 for cold start.
(Refer to the section Re-initializing the RMON MultiProbe Module
later in this chapter for information on the effects of warm and cold
starts.)
