3 - 32 Ethernet RMON MultiProbe Module Installation and Operation Guide
Assigning Interfaces to Networks
To assign RMON MultiProbe Module interfaces to networks, you can use
either:
❑ DIP switch settings, if your hub is unmanaged (an ONline or ONcore
management module is not installed in the hub).
❑ ONline or ONcore network management commands (if an ONline or
ONcore management module is installed in the hub).
You can assign the three RMON MultiProbe Module network interfaces as
follows:
❑ Interface 1 to Ethernet 1 or Isolated
❑ Interface 2 to Ethernet 2 or Isolated
❑ Interface 3 to Ethernet 3 or Isolated
Note: Each interface can only be configured to its corresponding
Ethernet network or isolated (that is, Interface 1 to
Ethernet 1, Interface 2 to Ethernet 2, Interface 3 to
Ethernet 3).
