Configuring the Module 3 - 35
Using Management Commands to Assign Interfaces to
Networks
With a terminal attached to a 3Com management module console, you can
use management commands to assign the RMON MultiProbe Module
interfaces to networks.
The following 3Com network management modules enable you to assign
interfaces to networks:
❑ ONline Ethernet Management Module (EMM) (Version V4.20)
❑ ONcore Distributed Management Module (DMM) (Version V2.10)
To configure all other RMON MultiProbe Module parameters (such as
IP address, subnet mask, and serial configurations), use the RMON
MultiProbe Module configuration menus.
Examples of the management commands for assigning networks are
discussed here briefly. For additional information on management
commands, refer to the appropriate management module commands
guide.
Note: Management commands that refer to ports are applicable
to the RMON MultiProbe Module interfaces. (For example,
the SET PORT and SHOW MODULE_PORT commands apply
to the module interfaces.)
