A SERVICE OF

logo

Service Calibrations
5-13
HP DesignJet 5000 and 5500 Series Printers Service Manual
5. On completing the Drop Detector calibration, the following
message is displayed:
6. On completing the calibration successfully, the following message
is displayed.
7. Press Back to return to the Service Calibrations menu.
If the Calibration fails, the following message is displayed. Error
codes are displayed for L2K (Line Sensor to black Printhead), DD
(Drop Detection) and Prim (Primer). Press Enter to continue.
NOTE Refer to 5-26, Calibration Error Codes to troubleshoot error
codes.
NOTE After the Calibration has been performed, print the Service
Configuration print to be sure that it has correctly been stored in
the EEROM. For information on the Service Config Print
Page 1-37.
Primer
Calibrating...
Please wait.
Calibrating line sensor.
2.2 Service Station
Press BACK to return
Calibration performed
Top
Enter
Back
n
p
Press Back
to previous menu
correctly
2.2 Service Station Calib
Calibration Error
L2K: xxxx
Press ENTER to continue
Top
Enter
Back
n
p
Press Enter
DD: xxxx
Prim:xxxx
Error 0000
means OK