System Error Codes
2-20
HP DesignJet 5000 and 5500 Series Printers Service Manual
System Error: 0B000F (Continuable) (Only applicable to DesignJet 5500 Series)
Problem
Description:
Unable to detect the Heater - If this error appears, all settings related
to the heater will disappear from the front Panel.
Corrective Action: Try the following:
Check that the cable from the Heater to the Main PCA is
correctly connected and is NOT damaged.
Replace the Heater Page 8-120.
System Error: 0C0030
Problem
Description:
Drop Detector Failure.
Corrective Action: Try the following:
Check that the Drop Detector Cable is NOT broken or damaged.
Check that the Drop Detector cable is correctly connected to the
Service Station Cable.
Remove the Drop Detector and make sure that there are no
obstacles inside which are blocking the sensor.
Replace the Drop Detector Assembly Page 8-72.
If the System Error Code continues, replace the Main PCA
Page 8-81.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
