Hewlett-Packard 5000 Manual

A SERVICE OF

next previous

Removal and Installation

8-40

HP DesignJet 5000 and 5500 Series Printers Service Manual

2. Insert the Trailing Cable Guide into

the Carriage and connect the Trailing

Cables.

NOTE Remember to pass the

Trailing Cables through the

Ferrite(s).

 3 for 60" Model.

 1 for 42" Model.

3. Insert the Trailing Cable through the

Chassis slot next to the Trailing Cable

Clip on the right (see diagram in step

4).

4. Place the Right Trailing Cable Clip in

position and adjust the length of the

Trailing Cable.

NOTE This clip has a locating pin so

make sure this is in position

and the Trailing Cable is the

right length before installing

the screw.

Right Clip

Slot

locating pin