A SERVICE OF

logo

Removal and Installation
8-36
HP DesignJet 5000 and 5500 Series Printers Service Manual
Trailing Cable
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Top Cover - Refer to
Page 8-5.
2. Remove the Right Rear Cover - Refer
to Page 8-16.
3. Remove the Right Hand Cover - Refer
to Page 8-10.
4. Remove the Left Hand Cover - Refer
to Page 8-6.
5. Slide the Carriage to the left side of
the Printer.
6. Unclip and remove the Carriage
Cover to access the Trailing Cable in
the Carriage.