Removal and Installation
8-52
HP DesignJet 5000 and 5500 Series Printers Service Manual
Installation of Carriage and Belt
NOTE Before installation, clean and oil the Slider Rods using the User’s
Slider Rods Lubrification Kit (Refer to the User’s Guide).
WARNING Make sure you install the Carriage Assembly and Belt as follows:
1. Insert belt as indicated on the
underside of Carriage.
TIP An arrow on the bottom of
the Carriage indicates
position and direction.
2. Line up the Carriage Guide, on the
underside of the carriage, with the
Slider Rods on the Printer.
NOTE Perform the following
Service Calibrations after
the installation of the
Carriage Assembly:
Carriage Height Page 5-18.
Service Station Page 5-11.
Scan Axis Page 5-7.
Printhead Alignment User Guide.
Color Calibration User Guide.
