Service Calibrations
5-27
HP DesignJet 5000 and 5500 Series Printers Service Manual
Calibration Error: 0000
NOTE This code is not an error. See the other codes reported.
Calibration Error: 0001
Problem
Description:
Pen voltage error.
Corrective Action: Try the following:
Power the Printer OFF and ON again using the Power Switch at
the back of the Printer and if a (XXXX)Replace message for a
particular Printhead is displayed, replace that Printhead.
If the (XXXX)Replace message is for all Printheads, replace the
Carriage Assembly Page 8-46.
Calibration Error: 0002 and 0003
Problem
Description:
Line sensor could not calibrate.
Corrective Action: Check the media used for the Calibration is WHITE.
Try the following:
Replace the Lens Cover Assembly Page 9-5.
Replace the Carriage Assembly Page 8-46.
Calibration Error: 0004
Problem
Description:
The Line Sensor pattern is not printed. Firmware error.
Corrective Action: Try the following:
Power the Printer OFF and ON again using the Power Switch at
the back of the Printer to reset the memory.
Upgrade the Firmware Page 9-13.
Calibration Error: 0005
Problem
Description:
Line Sensor error.
Corrective Action: Try the following:
Replace the Carriage Assembly Page 8-46.
