A SERVICE OF

logo

Removal and Installation
8-79
HP DesignJet 5000 and 5500 Series Printers Service Manual
Electronics Module Cover
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the LAN Card - Refer to
Page 8-76.
2. Remove Left Rear Cover - Refer to
Page 8-15.
3. Remove Right Rear Cover - Refer to
Page 8-16.
4. If present, remove the Ferrites from
the Ferrite Holder on the right side.
5. Remove 15 T-15 screws (Type B)
from the Electronics Module Cover.
Push clip to release Ferrite (if present)