A SERVICE OF

logo

Open as PDF
next previous
Fuser Kit - Replacing the Fuser
4-32 Ordering and Replacing Consumables
3. Maintain pressure on the fuser and finger-tighten the fuser locking knob clockwise to
engage the frame and secure the fuser into position as shown in Figure 4-37.
If the fuser does not seat properly, do not force it. Instead, refer to Figure 4-37 while
following the next two steps:
a) Hold the fuser up against the printer using light pressure.
b) Carefully rotate the decurler roller knob clockwise until you feel the gears turn
easily and the fuser seats flush against the printer. Tighten the fuser locking
knob.
Figure 4-37 Fuser Locking Knob and Decurler Roller Knob
4. Verify all locks and levers are secure and then close the front door.
5. Press Done.
Decurler roller knob
Fuser locking knob