Comms Menu Settings
Control Panel 2-23
Control Panel
Serial Interface Configuration Example
The following is an example of how to configure the serial interface.
1. On Comms menu, use
Ĭ
to highlight Serial. At Serial, use
Ǡ
to display selections.
2. Use
Ǡ
to display baud rates.
3. Use
Ĭ
to scroll to display selections (19200 selected).
4. Continue selecting the following parameters:
• Select stopbits and set the number of stopbits.
• Select parity and set the parity check condition.
• Select flow and set the flow control type of the serial interface:
NOFLOW Disable flow control.
XON/XOFF Enable XON/XOFF flow control.
ROBUST Enable ROBUST flow control (a combination of software and hardware
flow control).
• Select dtr and set the method of handling the serial interface Data Terminal Ready
(DTR) signal.
HI/LO DTR polarity high for ready and low for not ready
LO/HI DTR polarity low for ready and high for not ready
HI/HI DTR polarity permanently high
LO/LO DTR polarity permanently low
• Select levels and set the type of serial interface.
