Printer Pick Roller Kit - Replacing the Tray Pick Rollers
4-38 Ordering and Replacing Consumables
1. Install the smaller lower roller (torque limiter roller) so that the notch in the roller’s
plastic fits over the metal pegs on the shaft. When this roller is correctly in all the way,
the roller is locked and will not rotate. See Figure 4-47.
Figure 4-47 Correct Torque Limiter placement
2. Install the larger lower roller on the same shaft. The larger roller (when correctly
positioned) fits onto two small plastic pegs on the smaller lower roller. You may need to
rotate the larger roller against the smaller roller until it snaps into place. See Figure 4-48.
Figure 4-48 Correct Larger Lower Roller placement
Notch correctly positioned to go
over metal peg
Roller correctly installed all the way,
with notch over the metal peg
Larger lower roller positioned on the
same shaft as the smaller roller
Larger lower roller rotated to
engage plastic pegs on smaller
