Filter
Top Products
43
Bypass Mode: To bypass individual zones, enter a valid full function code followed by the 9 digit. The
system will speak "BYPASSED MODE, ENTER ZONE NUMBER." Press a two-digit zone
number (leading zero if necessary). The current bypass state of the zone is spoken.
Pressing A toggles the bypass status (confirmed in speech). Pressing H exits bypass
mode. To unbypass all bypassed zones, enter 00 as the two-digit zone number.
The following are system operation notes relative to bypass:
1) Bypassed zones will display open/close if programmed to do so.
2) Bypassed zones that show as open are ignored for purposes of forced arming.
3) No monitor speech or beep or alarm activation will occur for a bypassed zone.
4) Only zones that exist in the system can be bypassed. The system will issue 3-beeps
if an invalid zone number is entered.
5) Fire zones and disabled zones cannot be bypassed.
6) As a programmable option, any bypassed zone will automatically unbypass the next
time the system is disarmed. If this option is not programmed, bypassed zones will
remain bypassed until they are manually unbypassed.
Bypassing is not permitted in a UL installation.
Callback Wait Duration: The amount of time the panel will wait after a digital communication for the central
station to call during a two-way callback session.
Central Station Account: Each phone number has an account number associated with it. You may use a 3- or 4-
digit account number. If Ademco Contact I.D. is being used as the reporting format, a 4
digit account number must be used. The system allows additional characters as follows:
Hexadecimal Digit # or H Followed By
B1
C2
D3
E4
F 5
Central Station Handshake:This location determines the amount of time the communicator will wait for a central
station receiver digital handshake.
Central Station Number: Space is provided for two 16-digit phone numbers. These numbers are programmed as
normally dialed. To enter communicator phone numbers, enter the appropriate 9000
location and enter the number. The system places the numbers in the appropriate
locations. There are characters that are available in the dialing string that are not found
on the keypad. The chart below explains how to enter additional functions:
Dialing Feature # or H Followed By
Dial * 1
Dial # 2
Wait for second dial tone 3
3 second pause in dialing sequence 4
After the number is entered, press # or H key twice to save. Pressing the * or A key at
any time during phone number will clear all digits that have been entered.
Changing User Codes: To change user code, in keypad mode, enter a full function user code (default user 1 is
1,2,3,4), followed by the 7 digit. The system will speak "ENTER USER NUMBER." Press
the 2-digit number (01-08) for the user code you wish to change. You will then hear
"ENTER CODE (the number you selected)". The next four digits pressed will be the new
code. After the fourth digit, the system will speak "EXIT".
Clear EML and LTM: The Event Memory Log and Long Term memory can be cleared by entering 9898.